Rexroth MOTOR A6VM series A6VM55 80 107 160 250 A6VM80HD1/63W-VZB010B A6vm160ha2t/63w-vzb020a hydraulic motor piston pump

1.During speed regulation and operation, the axial piston unit must always be filled with hydraulic oil and discharged with air; After a relatively long period of downtime, it is also necessary to observe the appeal precautions, as the axial piston unit may drain hydraulic oil back into the tank through hydraulic lines.

2. The casing oil in the pump housing must be drained to the oil tank through the high oil drain ports (T1, T2).

3.For a combination of multiple equipment, it should be ensured that the corresponding casing pressure of each equipment is not exceeded. When there is a pressure difference at the oil drain port of the equipment, the common oil drain pipeline must be replaced. In any case, the minimum allowable pressure of all connected equipment must not be exceeded. If this cannot be achieved, separate oil drain lines should be laid if necessary.

In order to obtain favorable noise values, elastic elements should be used to separate all connecting pipes and avoid separate installation on the oil tank.

Under all operating conditions, the housing drain line must be routed below the lowest oil level in the tank.