PVS Series PVS40EH140C2 High Pressure Hydraulic Variable Displacement PVS08 PVS12 PVS16 PVS25 PVS32 PVS40 PVS50 Vane Pump

high pressure Hydraulic variable displacement 1. Installation and start-up For a safe and disruption free operation of any machine or system a careful installation and start up according to the manufacturers instructions is mandatory. Hydraulic systems can be designed for many totally different functions and they require consequently different start up procedures. The hydraulic pump is in this respect only one, but nevertheless a very important component of the whole system. A general start up instruction therefore can give many helpful hints but it needs to be completed by specific additions depending of the individual nature of the system or power unit.

PVS series PVS40EH140C2 high pressure Hydraulic variable displacement PVS08 PVS12 PVS16 PVS25 PVS32 PVS40 PVS50 vane pump

The suction pipe must have access to clean, cooled and filtered fluid, free of air bubbles. No turbulences or high flow velocities should occur at the tube inlet. Therefore position inlet as far as possible away from return line and drain line. Make sure that the fluid circulation in the reservoir does keep return flow from suction pipe inlet. In case of positive head use shut off valve in the inlet, monitored with proximity switch or equivalent to avoid start up of motor when valve is closed. When installed into the reservoir use short suction pipe with pipe end cut under 45°.