Rexroth PV7-1A25-45RE01MC0-08 Variable Vane Pump For Injection Molding Machine PV7-1X/10-14RE01MC0-16

Case drain On page 4 the average external case drain of the pump is stated. Consider, that these values are only meant to be project planning for determining cooler and pipeline sizes. The zero stroke power is the relevant factor for the dimensioning of the reservoir (see page 6 to 9). Restrictions in pipeline cross sections but also the use of a case drain cooler can cause impermissible high pressure spikes in the case drain line. Pressure safeguarding Pressure controller are not backups against pressure overload. A separate pressure-relief valve is to be provided in the hydraulic system

Technical data All the technical data are dependent on manufacturing tolerances and are valid with certain operating conditions. Please therefore take into account that minor variations are possible and technical data can be affected by differing conditions (e.g. viscosity). Characteristics for flow and absorbed power Please take into account when dimensioning the engine the maximum possible application data. Noise The values for sound pressure levels as shown on pages 6 to 9 were measured according to DIN 45635 part 26. That means, only the noise emission of the pump is depicted. Ambient influences (such as place of installation, piping, etc.) are not taken into consideration. The values only refer to one pump.

PV7.